another tav2 question!

[lyinlow]

i have a tav2 for a 1" bore that im not using i wanna put it on a 3/4" shaft.. what parts do i need to get and where could i get them???


Thanks in advance!

Trevor

[Gadget Man]

lyinlow

Check the web-site @ Comet Industries.
Ya, gotta go straight to the source dude.

http://www.hoffcocomet.com/comet/

Gadget Man:cheers:

[CritterBuddy]

Sorry dude, as far as I know they don't make an adapter kit to fit a 1" bore driver to a 3/4" shaft.

Thinking shade tree mechanics, I wonder if you could use a 1/8" sleeve with a slot in it for the key? You'd have to find a slightly taller key to make it work though. Strictly thinking out loud here....

[moto1fast]

Hello, They do not make a adapter for it! You can just replace the front drive unit and stationary plate, bushings, spacers BUT it runs about 100.00 plus shipping. Just found this sight where you can get it! Click on this link: http://www.mfgsupply.com/GoMiniClutchTorq30drive.html/mv_session_id=D8JAS6jR It might be better just to sell yours on ebay and get one to fit your 3/4" motor. The best place to get one is from Steve at BMI he is the cheapest. Hope this helps and Good Luck!:cheers:

[lyinlow]

hope someone with a tav 2 for a 3/4" shaft can help me here can someone measure the spacer that goes on the shaft before you put the front drive unit on ... i know its 3/4" id,whats the od? and how thick is it??