2 Stroker

[BSROKC]

I am thinking of putting a Honda CR80 engine on a BSR. Do you guys think that would be to much(as if there could be to much power). Can you think of any problems that I might have with powering my BSR with this engine? I realize that I would probly only get to 2nd or 3rd gear. I am just about ready to start building and any help would be appreciated.

[voodoo_stepchild]

Theres been some 2 stroke shifters built before. There is an enormous amount of power with the cr80 so remember lots of padding, a good brain bucket, and some gloves to prevent the gravel from getting into your palms when you hit the ground

Voodoo

[Woodchuckscustoms.com]

That motor will work fine. If you gear it right you can use 1st for a granny gear and use 2nd or 3rd to take off from a stand still. Eather way it will work.:cheers:

[BSROKC]

I will have to use that motor for something else. I have a 5hp B&S that has been bored and stroked and burns Methanol. I was told it sould have around 18HP and this thing flys. I can't even imagine that CR80 engine in one. I am thinking of an off-roader that it might work for in the future though.

[voodoo_stepchild]

How in the world are you getting 18 hp out of a briggs? Our raptors are stroked and bored .160 over and sleeved and we are only getting about 16 out of them. And thats with the big valves, 3 hp billet flywheel, big tilly on alky and jr 3 intake, rlv exhaust and major rod bending compression


Voodoo