Shut-R-Down

[Woodchuckscustoms.com]

I just picked up a new product for this great new sport!
We all have talked about idea's from how fast and how to stop but there is a saftey issue wa all should concider when building our machines.
If we fall of at a high rate even a slow rate of speed there should be a device to stop the motor from running thus stopping the maching from going nuts on ya!
Tether Saftey Kill Switch, these things work great and will adapt to ANY motor with a spark plug.:cheers:
Check out this link http://www.woodchuckscustoms.com/Part%20Pics/Tether%20Switch.jpg

PRICING: http://www.woodchuckscustoms.com/Parts%20Table%20Page.htm

[lyinlow]

i bought 2 of these off ebay from a sea doo... however iv yet to figure them out! if i have the teather off it runs... i put the teather on and the motor dies.. complete opposite of what i want?!?!?

any ideas?? im trying to wire this up to a 5.5 honda clone... pics would be appreciated as well!!

[Woodchuckscustoms.com]

i bought 2 of these off ebay from a sea doo... however iv yet to figure them out! if i have the teather off it runs... i put the teather on and the motor dies.. complete opposite of what i want?!?!?

any ideas?? im trying to wire this up to a 5.5 honda clone... pics would be appreciated as well!!

if you have a black and white wire hook the white wire to the motor and the black wire hookes to the frame:cheers:

[lyinlow]

i tried that but the switch works backwards... only thing i can think of is whatever this is from it has a backwards wiring setup?@?@?
heres the pics of the switch and my motors wiring

[Woodchuckscustoms.com]

just cross your wires from the way they are now and I would think that would do it.

[Thunderbolt51]

i bought 2 of these off ebay from a sea doo... however iv yet to figure them out! if i have the teather off it runs... i put the teather on and the motor dies.. complete opposite of what i want?!?!?

any ideas?? im trying to wire this up to a 5.5 honda clone... pics would be appreciated as well!!
there are TWO kinds of tether kill switches ( I use Artic Cat snowmobile n.c. switches on my tractor pullers) , N.C.- normally closed circuit - with cap in place (old style) and N.O. - normally open circuit - when you pull the cap the circuit is completed/closed. You probably have the later n.o. and need the former n.c. setup. Swapping wires doesn't change it.