Plans for a Tube Bender

[Ironfist104]

found this free plan to build a tube bender
http://www.metalwebnews.com/howto/tube-bender/tube-bender.html

[InsaneSpeed]

That is the exact same thing I built a few years back. It works great but I can only get a 95* angle bent. There is a threaded stop on the die that hits the bottle jack at that point. If you make one, watch for this.

Josh

[Mike Bean]

Ironfist,

Thanks for the link to the tube bender. I took your thread and made it sticky because I feel this is one thread we do not want to lose over time.

I also imported the entire page from the tube bender site in case it goes offline I will put up it here so we still have the plans.

Thanks again!

Mike Bean
:hot:

[Ironfist104]

I'm working on a draw style tube bender this bender should be able to bend almost 360* will post my plans as soon as I'm done with it this bender will bend squre tubing too...

[Thunderbolt51]

http://www.pro-tools.com/105k_info.html
http://www.pirate4x4.com/tech/bendin_tube/index.html

[moto1fast]

Great Information on bending "How To' and Best price so far I have seen for a bender and dies! When I get a few bucks saved up I will get one of these for sure! This needs to be posted and saved for us here! Thank You!:thumb: