Fitting Question

[fireplug]

I am about half way thru building a BSR. My question involves the fittings for the go kart supplied disc brake, hydraulic cylinder fittings. This setup was used on the donor kart with a 3/16" clear plastic line going into compression fittings on the master cylinder. Can I get these brass compression fittings with a 45 degree bend in them? That would work lots better on my set up than the straight ones that came with it. Any supplier links would be appreciated!!!

Can't wait to fire that bad boy up!!!

[Big Joe]

Yes, there are places to get the fittings. One is American Power sports and the other is BMI (Barhorst manufacturing Inc.) They both carry the fittings you need. Hope this helps.

Joe

[fireplug]

Thanks. Now I'm looking at braided stainless lines. This addiction might be worst than my other speed jones!!!