View Full Version : Gas movement
altrego30
January 30th, 2006, 01:49 PM
Is there a material that I could stuff in my tank to baffel the movement of the gas, every now and then my engine suck air down the line after a turn and my engine bogs down for a moment.
Canadiankid
January 30th, 2006, 02:18 PM
I know you can buy fuel cell's with some sort of foam baffle but I have never seen it out side of a tank. If nobody here can help I would try a local race shop.
Mike Bean
January 31st, 2006, 09:32 AM
I have not heard of adding a baffle after the tank was built. Even if you had the stuff, I would imagine it would be difficult to get inside the tank correctly.
Why don't you add come additional fuel line or add a section that has larger size line in one part to act like a small reserve until you're done with your turn?
Are you using the Tecumseh Power Sport engine? In the photo it looks like my engine. I have about 2 feet of fuel line in my system and I never get any flat spots and I ride on the two side wheel around culdesacs and long curves which pull the fuel away from my line hookup and I have never had a problem.
Mike Bean
RUBICON
January 31st, 2006, 11:53 AM
The ideas of line as a reservoir are great...what about a fuel filter in line...or just a stupid thought...keep the tank level higher....I installed a little larger line and a transparent filter...good luck
altrego30
January 31st, 2006, 10:27 PM
The ideas of line as a reservoir are great...what about a fuel filter in line...or just a stupid thought...keep the tank level higher....I installed a little larger line and a transparent filter...good luck
The inline filter idea I like, as for a stupid thought of fuel level, As I get low on fuel, I guess its a warning Im getting low.
Canadiankid
January 31st, 2006, 11:51 PM
Does this only happen when you are getting low on fuel or is it possible that you are having some sort of carb problem.
ROADFIXER1
February 1st, 2006, 01:26 AM
you can buy fuel cell foam in blocks from speedwaymotors.com I would say one block trim'd into a round shape the size of the tank will work well. the foam can be pushed thru the fill opening... hope this helps....
note:most fuel cell foam has 4 to 5 yr. life span before it strarts to break down..
RUBICON
February 1st, 2006, 01:17 PM
PLUS....With the fuel cell foam....when you crash-n-burn....you won't burn...at least in flames....
ROADFIXER1
February 1st, 2006, 07:59 PM
fuel cell foam won't do much for the crash and burn thing when used in a
metal tank.... if you crush and break a metal tank the foam in the tank won't stop any leakage....dont what to miss lead anyone.:hot:
RUBICON
February 1st, 2006, 08:59 PM
was not one of the attributes ....when a tank ruptured under impact that it reduced the rapid expulsion of the fuel that would engulf everything around the tank in flame...it limited the flow to a stream depending on size of the opening...??
altrego30
February 1st, 2006, 09:54 PM
I think I will look into an inline fuel filter.
vBulletin v3.5.2, Copyright ©2000-2012, Jelsoft Enterprises Ltd.