spindle question

[HotRodLincoln]

I was wondering if the spindles that are used on Jr Dragsters are the same as the ones used on bsr's & karts.
Thanks a lot, Gents


Drink'er up boys, it's well after 10:00:cheers:

[HotRodLincoln]

sorry, what i meant was hubs. the Jr Drag hubs i'm asking about are a 3 on 5.25" Is that the same as what would be found on your bsr's?

[stool-sample]

I believe its 3 on 2.25 I will check today for sure. You race jrs? Im getting ready to build a few of them .

[HotRodLincoln]

Na Stool, actually i'm thinking of building a drag wagon with Jr wheels & tires a healthy sized 4 stroke single clutch and all, i've dreamed up a sweet adjustable wheelie bar setup too

[stool-sample]

Ok I see where your headed. Im looking at building JR Dragsters here soon. Im gonna need more room in the shop now! lol

[RUBICON]

I ran my Stool after a jr dragster last week @ Greer Dragway...the jr went over 80 and in just under 7 sec...for those of you that don't know....thats faster than 90% of the fastest street cars...yes...big blocks and slicks included...I was amazed....but while I was admiring the billet single cylinder and all the super tech stuff I was told that was an $8,000 engine and dynoed @ 38hp on alky.....he was Virginia 2005 state record holder

[elvergon]

Wouw,...why not putting a 550 c.c engine bike and save 7,500 dlls :D