PDA

View Full Version : new barstool

motorman100
June 9th, 2005, 03:34 PM
heres how far i am on the barstool project, a friend and i are working on...
Chewbacca
June 9th, 2005, 04:05 PM
Hello.

Honda GX motor... ... VERY GOOD !!!

Chewbacca.
motorman100
June 10th, 2005, 02:04 PM
got the frame done....exept the nerf bars...
Mike Bean
June 10th, 2005, 02:23 PM
Hey Motoroman100,

Looking good. Your photos bring back memories of when I built mine.

Mike
motorman100
July 14th, 2005, 12:49 AM
UPDATE to the Project
Mike Bean
July 16th, 2005, 04:43 PM
Motorman,

Can you post a photo of the setup you used for the wheelie bar on the back?

Thanks!

mbean
motorman100
July 24th, 2005, 12:20 AM
all i did was cut some 1/4" steel with an angle grinder,drilled holes, then bolted the wheel to it.
motorman100
August 2nd, 2005, 02:36 AM
almost there!!!!!!!!!
Mike Bean
August 7th, 2005, 08:37 AM
Motorman,

Are you going to put the diamon plate on the footsteps?

Are you gong to get a small battery and use the electric start?

mbean
elvergon
August 18th, 2005, 09:34 PM
hey motorman it seems u got urself a 3/4" axle, is that right?
motorman100
August 19th, 2005, 01:16 AM
naw, its 1"
elvergon
August 19th, 2005, 03:05 PM
damn is 3/4" too weak or why? OMG :S im using a 3/4 and will have 18 hp1 :S is dat ok''
motorman100
August 23rd, 2005, 12:03 PM
engine is almost painted, gas tank will be red.
motorman100
August 24th, 2005, 01:31 AM
and more...
stool-sample
August 24th, 2005, 06:33 AM
Man I swear I just looked at this thing on Hardcore! lol Nice job man. That motor doesnt look Chinneese anymore. Glenn
motorman100
August 25th, 2005, 01:20 AM
more photos...
g2g2g07
September 1st, 2005, 06:22 PM
where did you get the axle and can you make one
motorman100
September 1st, 2005, 10:34 PM
i got it from bmi, you could make one, just get some 1" round bar, but you would probably need a mill to make the key way
motorman100
September 1st, 2005, 10:36 PM
heres the link. www.bmikarts.com
g2g2g07
September 2nd, 2005, 11:18 AM
think you for your help