got me a problem

[more speed]

well i was going to get a max torque 12T clutch, i like the option of inboard/ outboard mounting.

well my problem is i measured my wisconson's crank and its 1" im gunna check it again just to make sure i was not seeing things. problem is the clutch i was gunna get is a 3/4" bore. i need 1", so far ive looked and the 1" bore clutches are outboard only. i have a out board one but it will not work. i need to have the sprocket on the inside.

any ideas? id prefer a 1" bore, 12 Tooth, #35 chain size, inboard/outboard mounting type.

[Mike Bean]

From what I have heard, engines larger than the 6.5HP have a 1" shaft. Might have to special order it somewhere. Or mayber you can have the clutch machined.

Your eyes are correct, 1".

mbean

[more speed]

thanks mbean.

eh...special order sounds expensive:(

think maybe its time to see what my LMS conection has around for a possable trade, either a 6.5 of stright 6hp. the comet 400 clutch i have for it that is outboard cost like 90 bux as it is:shock: id shudder at what a special order one is.

well im off to a fun park for the day, kinda like disneyland but differet.

BTW: LMS= Local Mower Shop:D